I have an assignment in which I have to form the LIBs for the LSRs based on specific LSPs. My question is the following: I have two LSPs that have the same Destination IP Addresses, different Source IP Addresses and the second one uses the same last two LSRs as the first one.
The first LSP is the following: R1, R3, R2, R5 (Source IP: 220.127.116.11/24, Destination IP: 18.104.22.168/24) The second LSP is the following: R2, R5 (Source IP: 22.214.171.124/24, Destination IP: 126.96.36.199/24)
When I do the LIB for R5, I end up with two different registers that have the same Destination Address, Input Interface, Output Interface, Output Label (it actually does not exist since R5 is the Egress Router for both these LSPs), but different Input Labels. Is this possible? Shouldn't Input Labels be the same since the Destination IP Address is the same? From what I know, Labels have local significance, so Source IP does not play a role here.LIB-R5
Hello guys.I installed remote access VPN on Windows 2019. I need to do additional configuration on the router to allow access outside. I got this.Public IP--------------ISP Router-------------Fa0/0 Cisco Router Fa0/1------------------------My Server ...
Meet the Authors video - How to Troubleshoot Network Problems with Vinit Jain
(Live event – Wednesday, February 12th, 2020 at 10:00 a.m. Pacific / 1:00 p.m. Eastern / 7:00 p.m. Paris)
This event had place on Wednesday 12th, February 2020 at 10hrs PDT&nbs...
I have a pair of 3945 routers that are proving to be underpowered for the 100+ remote offices connecting to them. Fortunately I happen to have a couple of 4351 ISRs rated for significantly greater encrypted throughput. Is there any way I could upgrade the...
This article assumes you have the basic knowledge and experience with Cisco DNA Center and Identity Services Engine (ISE).Note when reading this doc the "Authentication Policy" referred to is part of Cisco DNA Center Onboarding section and ha...