MPLS Over EThernet Xconnect More than two sides

[silviorodrigues]

Dears good morning!

I have a Site Headquarters and 2 Customer Sites! The lan network Site Headquarters is: 192.168.0.0/24 Vlan 30 and I need extended this lan to my two sites Costumer A and B.

I trie do this with command below!

int f0/0.30

encapsulatio dot1 30

xconect 2.2.2.2 20 encapsulation mpls

xconect 3.3.3.3 30 encapsulation mpls

The problem is that xconect 3.3.3.3 30 overrides xconect 2.2.2.2 20

for clarity, follow a topology!

Thank alot for your help!

[rsimoni]

Hi Silvio,

EoMPLS (what you have) is a point to point technology. So you can create pseduwires beetween 2 sites only.

To connect more than 2 locations at L2 you need VPLS which is supported only on some specific platforms with specific hardware.

Have a look at this page to know more about it:

http://www.cisco.com/en/US/partner/products/ps6648/products_ios_protocol_option_home.html

regards,

Riccardo