12-03-2007 09:34 AM - edited 03-05-2019 07:47 PM
I am having two new bonded T1 lines installed at my facility. These are replacing the two lines I currently use. A Primary and a shadow. I will need to configure my router to accept the bonded T1 lines. I have a Cisco 3600 series router, running the 12.3 IOS. Can someone please help me with the configuration steps to complete this properly.
Thank You,
Mike Sullivan
12-03-2007 09:49 AM
12-03-2007 10:34 AM
there a couple different ways you can do this. probably want to use CEF or MLPPP. Here's an example with MLPPP:
interface Multilink1
description connected to internet
ip address 24.234.1.1 255.255.255.252
no cdp enable
ppp multilink
ppp multilink fragment disable
ppp multilink group 1
!
interface Serial0/0
description multilink 1 interface
no ip address
encapsulation ppp
no keepalive
no fair-queue
ppp multilink
ppp multilink group 1
!
interface Serial0/1
description multilink 1 interface
no ip address
encapsulation ppp
no keepalive
no fair-queue
ppp multilink
ppp multilink group 1
-brad
(please rate the post!)
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide