Multicast Nexus7000 - sh ip rpf

[marcelletm]

The command "show ip rpf x.x.x.x"  is very useful for multicast troubleshooting but I am surprised that I cannot find it on the new operational system NXOS... does anyone know if there is an equivalent command?

Thank you,

[Dale Miller · Accepted solution]

The command in NX-OS is " show ip route rpf" shows the RPF table used for multicast source lookup.

For similair queriers check out the docwiki for Nexus 7000

http://docwiki.cisco.com/wiki/Cisco_Nexus_7000_NX-OS/IOS_Comparison_Tech_Notes

There is a good NX-OS to IOS command comparision table.

Regards,

Dale

[marcelletm]

Dale,

Thank you very much for the answer and the doc. Very useful!!!

Regards,

Marcelle