Switching

Discuss Catalyst brand switches with peers and experts.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Labels

Forum Posts

Good Afternoon All,Looking for kind of a step by step guide. My org recently purchased 3 9300L switches. Two of them are 24p's and the other is a 48p. I am assuming I can write one file then make small tweaks due to the port capacity. These switches ...

rjkmd by Community Member
  • 153 Views
  • 7 replies
  • 0 Helpful votes

I was applying the config on my C9300-NM-8X and according to the documentation all of the expansion ports should be TenGigabitEthernet.  After applying the desired config the results of show run there are 4 GigabitEthernet, the 8 TenGigabitEthernet i...

benbioman by Level 1
  • 136 Views
  • 6 replies
  • 0 Helpful votes

I recently replaced the core switch at one of my sites that consisted of two separate C9300-48Ts and three other off brand switches and installed a new stack with a C9300X-48HX, C9300-24S and a C9300-48T (running 17.12.5). This is a layer 2 network c...

dbronco by Level 1
  • 219 Views
  • 8 replies
  • 0 Helpful votes

I have a WS-C2960X-48TD-L Switch and in this switch routing, routing protocals are working fine even it is L2 Switch. But when I try to enter the command as "no switchport" in the interface mode, it is not working.Actually it is Layer2 switch or Laye...

srinivask2 by Level 1
  • 18694 Views
  • 6 replies
  • 0 Helpful votes

Hi Team,Users in my network are receiving bad IP addresses, and our DHCP scope is set up on a Microsoft Windows Server.Please assist me in resolving this issue and let me know if you need any information from my side.

I have a Cisco CBS350 series. It was fine for a while. It started with I could not login. Password would not work. Now I have tried to set it back to factory, but None of the username passwords work and the boot light does not fast blinking. Serial o...

Dan67 by Community Member
  • 169 Views
  • 2 replies
  • 0 Helpful votes

Hello everyone,I have been implementing Cisco ACI MultiPod. in DC1 i have several services using gateway in DC2. how can i create BD or anything in order to services in DC1 can reach gateway in DC2.From my point of view, they can reach gateway via IP...

Good Day All, I currently have a C9300-24P-E , brand new out the box. I see that we are going to need AVB support which is only supported under DNA-Advantage licensing............ I tried to run the "license boot level network-advantage" command to t...

Also sorry, english isn't my native language so I tried to translate the assignment as best as I could.I only managed to do the DHCP server & I am not sure if I did it correctly or not. Because I tried other things like doing the ethernet channel but...

y47da25nu3af1.png
Vishnu by Level 1
  • 428 Views
  • 9 replies
  • 0 Helpful votes

Hello Cisco community,  I have a Cisco 9200L.  For some reason, we have had no luck migrating from password 7 to password 6.  Each time I attempt config, it gives me an error.  I even tried a new switch for additional testing, but still gives same re...