04-28-2019 08:19 AM - edited 04-29-2019 02:14 AM
Hi All,
I have been able to configure spanning tree and a port channel to help with redundancy. The issue I am facing now is that when I switch the left side multilayer switch off the right side will not allow pings from the clients to the routers.
All my VLANS are set on my router including ACL's. I have compared the configs of both switches and they look the same (to me anyway). Spanning tree takes a while but does eventually kick in. The left switch would always be primary due to its fibre connections but as the router will not accept any additional fibre connections the right side is set as a gb-ethernet.
Thanks for any help provided :) The packet tracer file is attached. If you do not have packet-tracer I would still appreciate help from ideas and troubleshooting.
04-28-2019 08:53 AM
04-28-2019 08:56 AM
04-28-2019 11:07 PM
Hello Dear :)
Have a good day
All thing is going well, can you share the # show standby output and port-channel mood which you used it.
the Scenarios :
IF you are using HSRP @ you will grouping them with one number like this
#interface xx
# Ip address 10.x.x.x 255.x.x.x
# Stand by 10 priority xx [ highest one will be active - lowest one will be stand by]
# stand by 10 Ip 10.x.x.x [ default gateway for both ]
also same thing in the another Mls
04-29-2019 03:16 AM
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide