Multiple VLAN trunk on gig port

[Ankit Dangwal]

Hi Guys,

    I've a Cisco switch 2960G. i want to trunk multiple vlan on a single port gig0/45 without assign ip address. i already created all vlan and trunked it on a single port but its not working.

i'm using Cisco Network Assistant. please help me out.

[szain]

Hi Ankit,

What is the device connected to the other end?

What is the current config, please share?

What exactly do you mean when you say it is not working?

Thanks

Sal

[Ankit Dangwal]

please tell me only one thing that can i trunk multiple vlan on a single port without assign them ip address? 

if yes then how?

please share to me.

[Mark Malone]

That should be all you need , both sides need to be set that way between the switches if your trunking between them , this will allow all vlans , youc an lock it down further with switchport trunk allowed vlan x,x,x

interface GigabitEthernet 0/45
 switchport mode trunk
end