N7K F3 & M1 cards on same VDC

[gopalakrishnanthangavel]

Hi,

We have a pair of N7K running in stand alone mode, we want to change the operation mode to support VPC, proucred N7K-F348XP-25= modules to get 10G ports, presently switches are populated with N7K-M148GT-11L modules, Can I put F3 & M1 in default VDC?

If not in the default VDC then is there any other way to put these cards in same vdc?

Thanks,

Gopal

[Reza Sharifi]

Hi,

You should not have any issues putting both modules in the global VDC. Global is the main default VDC.

HTH

[nightdreamer0]

Hello,

According to the following chart M1 and F3 in the same VDC is not supported. What do you think?

Thank you

https://www.cisco.com/c/dam/en/us/td/docs/switches/datacenter/nexus7000/sw/matrix/technical/reference/Module_Comparison_Matrix.pdf