hello,
i have a NAT failover configured on my 1942 router. (The config file is attached to this post). Main link is ISP1 and secondary link is ISP2. The secondary link is connected to one of the EHWIC switchports at the back of the 1942 router. The c...
Hello, we currently have a single core 6509 and we want to add another one to form a vss system. Is the process the same as configuring vss and will anything happen to the config on the existing switch when we reload?
thanks
Hi we are planning to configure CPU and Memory Threshold Notification for Cisco 3650.
we need to set below mentioned Processor, IO memory threshold and memory reservation for critical notification.
memory free low-watermark processor <threshold>memor...
Experiencing multicast issues on Cat9400 (CAT9K_IOSXE), Version 16.6.4 for only SOME users not ALL. Previous steps were:
* Upgrading to 16.6.4 (worked for one week then problem came back)
* Reboot switch (worked for one week then problem came back)...
Hello -
I have some 2960x stacks that are dropping their 10g connections back to their main closets. This is a straight fiber connection to and from the main switch in the building and the edge switch drops it's connection to the main switch for abou...
Hi all,
I have a C3750e switch which is running ipbase license. Recently, I have to apply PBR on this switch and the IOS version allowed me to apply the configuration properly. However, I found the PBR is very strange. I have traceroute the traffic...
Hi everone,
what is the difference between Anycast RP and MSDP? Does MSDP requires point-to-point connection to the peer? and Anycast RP does not require?
Thanks
Hi, I probably exagerating, but I just want to confirm
we have 2 6500 boxes (one SUP each) not in VSS just independent boxes with firewall service modules on each box
we have only updagraded the secondary box and we verified asa failover is in plac...
Hi guys,
As the title says, I have an issue backing up my 6880 switch. I get the following error:
Fetch VLAN
UnknownHANDLER_ERRORHandler Error com.cisco.ifm.customPalHandler.palHandler. Command failedERROR_HANDLER_ERROR
Running the followind IOS...
Other than what is in the QOS SRND, does anyone have any working Scavenger Class examples?The SRND states to include in this class peer-to-peer media sharing apps like KaZaa, Morpheaus, etc, gaming apps, and entertainment video, but it gives no worki...
Hi,
During initial boot up of the switch after joining to STACT i saw that the state is "Version Mismatch"
then after the reboot - i wasn't able to see the switch anymore. so i disconnected to stack connection and after that i reboot the switch and...
I need to run the Show tech command, but the N5K displays the error message. Has anyone faced this kind of problem?
SW-7A# show tech-support
---- show tech-support ----
who: write error: No space left on device
----- Time Taken for ...
Dear all,
I would like to know Jumbo frame.I know Jumbo frame is use for connection sensitive application or the applications need massive data input and output.it MTU is more 1500 and less 9000 .I know that.
I want to know benifit of using jumbo fra...
Hi could you please help me on following (very sorry about my english).
Kindly refer attached network topology.
currently we are in the process of implementing our DR Datacenter, (our DR site is installed on local internet service provider (ISP) pr...
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:
.jpg "VIP Community Legend"){kind=icon}
.jpg "Hall of Fame Master"){kind=icon}
