I'm trying to set up an Apache webserver within my network that our users can access from outside(public IP).
The web server is up and running - I can navigate from my network to IP 192.168.2.32
However I am unable to hit it using the public IP assigned 12.218.xxx.xxx
I have included some of the config below if anybody has any ideas:
interface FastEthernet0/0 ip address 12.218.xxx.xxx 255.255.255.248 ip nat outside ip virtual-reassembly duplex auto speed auto service-policy output physical ! interface FastEthernet0/1 no ip address duplex auto speed auto ! interface FastEthernet0/1.1 description LAN encapsulation dot1Q 1 native ip address 192.168.2.254 255.255.254.0 ip access-group 120 in ip flow ingress ip flow egress ip nat inside ip virtual-reassembly
! ip forward-protocol nd ip route 0.0.0.0 0.0.0.0 12.218.xxx.xxx ip route 10.5.5.0 255.255.255.0 10.5.1.1 ip route 10.10.0.0 255.255.255.0 172.17.0.5 ip route 10.10.200.0 255.255.255.0 172.17.0.5 !etc etc...
! ip flow-top-talkers top 20 sort-by bytes cache-timeout 3000 ! ip nat inside source list 2 interface FastEthernet0/0 overload ip nat inside source static 192.168.2.32 12.218.xxx.xxx extendable ! access-list 2 permit 192.168.2.0 0.0.0.255 access-list 2 permit 10.5.5.0 0.0.0.255 access-list 2 permit 10.5.1.0 0.0.0.255 access-list 2 permit 10.27.131.0 0.0.0.255 access-list 2 permit 10.27.129.0 0.0.0.255 access-list 2 permit 172.17.0.0 0.0.0.255 access-list 2 permit 192.168.50.0 0.0.0.255 access-list 120 permit tcp host 192.168.2.23 any eq smtp access-list 120 permit tcp host 192.168.2.27 any eq smtp access-list 120 permit tcp host 192.168.3.201 any eq smtp access-list 120 permit tcp host 192.168.2.13 any eq smtp access-list 120 deny tcp any any eq smtp access-list 120 permit ip 192.168.2.0 0.0.1.255 any access-list 120 permit ip 10.27.131.0 0.0.0.255 any access-list 120 permit ip 10.27.129.0 0.0.0.255 any access-list 120 permit ip 10.27.130.0 0.0.0.255 any access-list 120 permit ip 10.10.200.0 0.0.0.255 any access-list 120 permit ip 10.10.0.0 0.0.0.255 any access-list 120 permit ip 172.17.0.0 0.0.0.255 any access-list 120 permit udp any any eq bootps access-list 120 permit udp any any eq bootpc access-list 120 permit ip 192.168.50.0 0.0.0.255 any access-list 120 permit ip host 12.218.xxx.xxx any access-list 120 permit ip any host 12.218.xxx.xxx access-list 150 permit ip any 192.168.50.0 0.0.0.255 access-list 150 permit ip 192.168.50.0 0.0.0.255 any
Introduction to Routing ProtocolsStatic vs DynamicDistance Vector vs Link StateRoute Selection AlgorithmSingle Routing Protocol OnlyOpen Shortest Path First (OSPF)AreasRoute ConvergencePath SelectionMetric CalculationCharacteristicsEnhanced Interior Gatew...
Cisco DNA Center version 2.2.2.x includes the features and improvements that
New intelligence provides an easy, gradual, and complete adoption of SD-Access. Faster Cisco DNA Center set-up saves time and effort.
When using Cisco cellular modules with a SIM card an APN must be provided. The APN cannot be stored in the SIM card and is supplied by your SIM card provider. Cisco cellular software contains a database of well-known APNs based on the country and ...
Cisco 3850: IOS-XE/Firmware Upgrade
This procedure is aimed at Cisco 3850 switch ONLY.
IOS-XE Bundle Mode is not covered.
9300, 9500 (vanilla & high-performance), ISR 1k, ISR 4k and ASR is not covered.
Listen: https://smarturl.it/CCRS8E46Follow us: twitter.com/ciscochampionsIt’s been several years since the release of Cisco DNA Center, and it’s matured into a complete network management system, an automation and orchestration engine, an AI/ML analy...