I am trying to load the latest protocol pack on a C1921 (ISR G2)
I have the required IOS (15.2(4)M1)
I have the required license (Data)
I have downloaded the latest protocol pack to my tftp server (also put a copy on the router's flash)
The CLI command to specify the protocol pack does not provide syntax as described in the documentation.
What I get is
C1921-202TL(config)#ip nbar protocol-pack ?
ftp: Load protocol pack from ftp:
http: Load protocol pack from http:
https: Load protocol pack from https:
pram: Load protocol pack from pram:
rcp: Load protocol pack from rcp:
scp: Load protocol pack from scp:
tftp: Load protocol pack from tftp:
and when I try to specify, tftp, it provides no context for tftp arguments and will not accept no arguments...
C1921-202TL(config)#ip nbar protocol-pack tftp: ?
force Force
<cr>
C1921-202TL(config)#ip nbar protocol-pack tftp:
% NBAR Error: Unable to open file
It never reaches a context to complain about the file itself, only that the file is not properly specified.
I'm probably missing something obvious. Any helpful ideas?
Thanks.
