Need help with l3 intervlan routing

mzumarawongani57 · ‎01-13-2022

I want to route between vlans using layer 3 switches and also route from the vlan to router 0

So i have configured the vlans on sw1 and sw2, i have also configured SVI for all vlans on L3 switches

i have enabled routing already, trunk have been configured

but when i check the routing table only int vlan 1 appears

how can i configure this ?

Help! thank you

paul.driver · ‎01-13-2022

Hello

Is this a packet tracer lab, if so can you attach this labs file.

paul driver · ‎01-13-2022

Is this a packet tracer lab, if so can you attach this labs file.

EDITED -Please ignore the post below - Cisco are doing something with my profile and for some temporary time i lost all my posts for the passed 10 years! I didn't realize until I replied to your post .

Please rate and mark as an accepted solution if you have found any of the information provided useful.
This then could assist others on these forums to find a valuable answer and broadens the community’s global network.

Kind Regards
Paul

Martin L · ‎01-13-2022

check L3 SVI state UP? with show ip interface brief command. is it UP UP?

you may need a host for vlan x to bring SVI x to UP/UP state. Note that PT does not have auto-state exclude command that would let us keep SVI UP while there are no hosts connected to vlan / switch or hosts are down (turned off).

Also, double check vlans are present in the vlan database and allowed on trunks.

Regards, ML
**Please Rate All Helpful Responses **