Netflow-Lite on the 2960-x switch

[Andy White]

Hello,

I'm trying to take a look at the Netflow feature of the new 2960-x switch and I'm following the commands on the below URL but I'm getting stuck as my source to our LAN is an etherchannel and it won't let me use a port-channel as a source, shall I just use of the gigabit ports that are part of the etherchannel?

http://www.cisco.com/en/US/prod/collateral/switches/ps5718/ps12995/solution_overview_c22-728776.html

Thanks

[acampbell]

Andy,

Looking at a config guide for the 2960x

http://www.cisco.com/en/US/docs/switches/lan/catalyst2960x/software/15.0_2_EX/fnf/configuration_guide/b_fnf_152ex_2960-x_cg_chapter_010.html

Prerequisites for NetFlow Lite

The following are prerequisites for your NetFlow Lite configuration:

• NetFlow Lite is only supported on switches running the LAN Base image. Switches running the LAN Lite image do not support NetFlow Lite.
  
• Two targets for attaching a NetFlow Lite monitor are supported:
  
  • Port—Monitor attachment is only supported on physical interfaces and not on logical interfaces, such as EtherChannels.
    
  • 
    
  • VLAN—Monitor attachment is supported on VLAN interfaces only (SVI) and not on a Layer 2 VLAN.
    

Regards,
Alex.
Please rate useful posts.