08-22-2007 06:33 PM - edited 03-05-2019 06:03 PM
I have a layer 3 switch, gi1/1 & gi2/1 is port-channel and the channel port is a routed port. I have configured "ip flow ingress" for interface port-channel1, gi1/1 & gi2/1. But it seems that the netflow doesn't work. Below is the inteface config. Is there any config mistake.
int port-channel1
ip address x.x.x.x x.x.x.x
ip flow ingress
int g1/1
channel-group 1 mode on
ip flow ingress
int g2/1
channel-group 1 mode on
ip flow ingress
Thanks.
08-28-2007 02:09 PM
Follwoing commands used to configure Netflow for the CatOS.
set mls flow
set mls nde enable.
08-28-2007 07:25 PM
what kind of cisco switch/router is this???
That makes a difference.
08-30-2007 07:45 PM
i am using catalyst 6509 with native ios.
Thanks.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide