Switching

hello all,I notice looging in the log of 6513 core the following errors: Jul 16 09:37:39.481 extende: %DUAL-5-NBRCHANGE: IPX-EIGRP 767: Neighbor 1D113.000e.d665.d9fc (Vlan113) is down: holding time expiredJul 16 09:37:54.817 extende: %DUAL-5-NBRCHANG...

I'm going to be installing several 4506 switches running Sup4 cards, and am considering using MST for the rapid convergence etc. These are core switches supporting 2960's at the edge. Reading the documentation I see that the 4506 supports VTP v2, and...

This is probably a stupid question, but that hasn't stopped me before, so:If I had a sever in a DMZ and needed to set up a secondary NIC on it and I had no other interfaces for additional DMZs,Is there a secure way to set up the second NIC for point ...

Please tell me the use of this commandchannel-group 1 mode on and port channel 1

hi,I have around 300 customer at same diameter of 500 mts i need to desing the network and provide the internet access for all the users how it possible and it should be manageable Please help me out for the same mdmaqdoom@gmail.comRgdMaqdoom.M

Hi all, I believe that layer 2 we use frames and layer 3 we use packets, my question is when 2 pc's on the same lan talk to each other, are only frames involved as its all layer 2 ??

hi,i want ask about if it's possible to configure snmp on router for sending trap when there is a modification on his config.if yes how can i do this.thanks.

Dear sir, Iam having cisco catlyst 2960 48ttl switch in this i want to load HTML in this switch.because i want use this switch through webbrowser. but in this flash no html file plz tell me how can i load this html and its a folder. One more help plz...

Hi,A Gigaehternet module of Cisco 6509 prompts a disabling log when the device reloads/reset.I wander if it'll affect the function of this module.If it will,which function will be lost?Following is the detail of the diabling log:00:02:02: %DIAG-SP-6-...

Day 1, network is fine. I go home for the day. About 9:00 pm, I get alerts of overheating and we shutdown.Day 2, AC is repaired, bring network back up. There are 3 networks that are not quite working right. vlan 201 is a /22 network. Vlan 901 is...

Hi to all,I wanted some help regarding the type of switches and routers to use in a network setup of mine (attached "setup1.gif" image), which makes use of per-packet load balancing. I wanted some help regarding 2 network traffic scenarios:1) When tr...

Hi there,can you do traffic shaping based on ip addresses? In My DMZ i have several servers all having the same gateway to the internet. My gateway router is a 2611XM. I want limit one server for example 256 Kbs (up-down) to the internet and the othe...

Hello,I met following problem when using Cisco 1811 to route traffic via LAN and ISDN line. Routing via LAN is ok but there is not any response from ISDN card despite of the fact the booting is ok, and system recognizes the bri0/0/0 and it is possibl...