Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, I have successfully created a L2L IPSEC tunnel between a PIX501 and a VPN3030. The problem I have is I can only send traffic from the 501 --> 3030, the 3030 does not transmit any packets back across the tunnel. I have played around with many...
Hi, I currently have an AS5350 with 1 NP60 and 1 2PRI cards. We want to add an NP108 card but I am unsure of 'licensing' or what else I may need when upgrading by adding this card. Any advice on this? Here is the sh ver:#sh verCisco Internetwork O...
Hello all, I just installed a NM2V with a VIC2-2EM into a 2651 router. I can't for the life of me get the router to recognize the boards. I've tried a few IOS versions (12.2 8T5) and (c2600-ipvoice-mz.123-4.T4.bin) which was recommended by our SE. ...
HERE IS THE PROBLEM:*Jun 14 12:25:54: %CDP-4-DUPLEX_MISMATCH: duplex mismatch discovered on GigabitEthernet4/10 (not full duplex), with 3550_2 GigabitEthernet0/1 (full duplex).I am pretty sure it's something wrong with the setup of the trunking, but ...
We have a major problem on our network. Seems broadcast storms are increasing in frequency and intensity. Basically, here's the topo of the LAN. Dual 6509's with MSFC's. Into them dual connected are a 4003, 4006, and a dozen or so 3548's. Connecte...
I HIGHLY recommend you download some free existing network monitoring tools and get an idea of what the do and the "look and feel" of them.http://mrtg.orghttp://cacti.netIf you are going to implement a new tool, you need to know what the other well a...
I have two 7600 SUP720 PFC3BXL routers that take the full BGP table and one runs at 6% and the other at 9% consistently with little to no spikes in CPU.
I think this would be very difficult because you are talking about two different things.You can easily implement something to monitor the network in your building and identify which server / ports are congested. However, loadbalancing is a different...
I don't think this is possible with CiscoWorks.For this, I recommend using netflow and then you can breakdown by application (if you know the relevant ports) and do alarming, depending on how you implement the netflow tools. There are quite a few gu...
Kindly let me know what exactly this number is...like 1800,2800, and so on... just search on the cisco.com site.actully cisco having any specific reason?no would be a good answer. Also, what exactly are you trying to accomplish? In all reality it d...
