Hi,
configured NetFlow on a 3750-X with Network Module,
but it generates only interface-tables, no templates or flows.
Here my Config:
flow record Ingress
match datalink source-vlan-id
match datalink dot1q priority
match datalink mac source-address
match datalink mac destination-address
match ipv4 version
match ipv4 tos
match ipv4 ttl
match ipv4 protocol
match ipv4 source address
match ipv4 destination address
match transport source-port
match transport destination-port
match interface input physical snmp
collect interface output snmp
collect counter flows
collect counter bytes
collect counter packets
collect timestamp sys-uptime first
collect timestamp sys-uptime last
!
!
flow record Egress
match datalink destination-vlan-id
match datalink dot1q priority
match datalink mac source-address
match datalink mac destination-address
match ipv4 version
match ipv4 tos
match ipv4 ttl
match ipv4 protocol
match ipv4 source address
match ipv4 destination address
match transport source-port
match transport destination-port
match interface output physical snmp
collect interface input snmp
collect counter flows
collect counter bytes
collect counter packets
collect timestamp sys-uptime first
collect timestamp sys-uptime last
flow exporter export-to-Paessler
description PRTG Network Monitor - NetFLow
destination 10.10.10.27
source Vlan5
transport udp 9991
template data timeout 60
option interface-table timeout 60
!
!
flow monitor FlowMon_Ingress
record Ingress
exporter export-to-Paessler
cache timeout active 60
!
!
flow monitor FlowMon_Egress
record Egress
exporter export-to-Paessler
cache timeout active 60
!
interface Vlan91
ip flow monitor FlowMon_Ingress input
ip flow monitor FlowMon_Egress output
sh switch service-modules
Switch/Stack supports service module CPU version: 03.00.65
Temperature CPU
Switch# H/W Status (CPU/FPGA) CPU Link Version
-----------------------------------------------------------------
2 OK 58C/66C connected 03.00.65
