new blade not recognized...

[davisr651]

I recently added 2 more 48-port  gigbit blades in my Cisco 4510R switch chassis, which is now maxed.. the blade in slot 8 is recognized no problem, but the blade in slot 9 is not....

to rule out the blade being the issue, i removed the blade from slot 8  where it was working, and put in slot 9, and still did not work...

any ideas?

thanks

rob davis

[davisr651]

sh mode results....

so,  i can t put the ... WS-4548--GB-RJ45 in slot 10? 

[Jon Marshall]

davisr651 wrote:
sh mode results....
so,  i can t put the ... WS-4548--GB-RJ45 in slot 10?  

Unfortunately no you can't. As per previous post you can only put those linecards mentioned. If you had a sup V-10GE then you would be able to use that linecard in slot 10.

Jon

[davisr651]

What is the differernce between a v-10  and v-10ge?

[Jon Marshall · Accepted solution]

Rob

The sup V-10GE has 2 x 10Gbp uplinks on the supervisor. It also increases the available switching fabric which is why you can run all linecards in slot 10.

Jon

[davisr651]

Thank you for your  expertise...

have a good weekend...

rob davis