cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
8147
Views
3
Helpful
2
Replies

New to Cisco C9300,what is the default login and Password using Telnet

olalekan jimoh
Level 1
Level 1
2 Replies 2

M02@rt37
VIP
VIP

Hello @olalekan jimoh,

Do you have a prompt? Because By default, Cisco Catalyst C9300 switches do not have Telnet enabled. Telnet is considered an insecure protocol and is generally not recommended for device management.

 

Best regards
.ı|ı.ı|ı. If This Helps, Please Rate .ı|ı.ı|ı.

there is no username/password for telnet if it first time config 
you need to use console to access SW and add user mane password and config vty with login local 
NOTE:- when you add username/password config enable password and remember these password 

Review Cisco Networking for a $25 gift card