Hi,
if I snmpwalk Nexus 5000 running System version: 4.1(3)N1(1a) like
snmpwalk -v 2c -c <community> <ipaddr> ifTable
I see all ifIndex, for Channels, 10G Ports und also FEX Ports. Further I see ifDescr, ifType, ifMTU etc. (all statical variables) for all these ifIndex, but I miss ifInOctets, ifInNUcastPkts, ifInDiscards etc. (all dynamical counters) for all the FEX ports (ports an 2148T itself).
Funnily I also miss the FEX interfaces in output of
sh inter snmp-ifindex
--------------------------------------------------------------------------------
Port IFMIB Ifindex (hex)
--------------------------------------------------------------------------------
Eth1/1 436207616 (0x1a000000)
Eth1/2 436211712 (0x1a001000)
Eth1/3 436215808 (0x1a002000)
Eth1/4 436219904 (0x1a003000)
Eth1/5 436224000 (0x1a004000)
Eth1/6 436228096 (0x1a005000)
Eth1/7 436232192 (0x1a006000)
Eth1/8 436236288 (0x1a007000)
Eth1/9 436240384 (0x1a008000)
Eth1/10 436244480 (0x1a009000)
Eth1/11 436248576 (0x1a00a000)
Eth1/12 436252672 (0x1a00b000)
Eth1/13 436256768 (0x1a00c000)
Eth1/14 436260864 (0x1a00d000)
Eth1/15 436264960 (0x1a00e000)
Eth1/16 436269056 (0x1a00f000)
Eth1/17 436273152 (0x1a010000)
Eth1/18 436277248 (0x1a011000)
Eth1/19 436281344 (0x1a012000)
Eth1/20 436285440 (0x1a013000)
Eth2/1 436731904 (0x1a080000)
Eth2/2 436736000 (0x1a081000)
Eth2/3 436740096 (0x1a082000)
Eth2/4 436744192 (0x1a083000)
Eth2/5 436748288 (0x1a084000)
Eth2/6 436752384 (0x1a085000)
Po1 369098752 (0x16000000)
Po8 369098759 (0x16000007)
Po10 369098761 (0x16000009)
Po11 369098762 (0x1600000a)
Po12 369098763 (0x1600000b)
Po113 369098864 (0x16000070)
Po114 369098865 (0x16000071)
Po115 369098866 (0x16000072)
Po116 369098867 (0x16000073)
Po117 369098868 (0x16000074)
Po118 369098869 (0x16000075)
I lookes in config guides and command references and found no hint about this, but I found in datasheet of 2148T a simple entry under SNMP MIBS: IF-MIB without remark.
Any ideas?
Thanks
Mark
