nexus 5020 mac-address-table

[newbie]

when i try to enter more than one interface

like the below I get 'invalid number of interfaces specified'

mac-address-table static  0000.0000.0000 vlan 10 interface eth1/17 eth1/21 eth1/25

[sachinraja]

Hi

Im not sure about the particular platform of Nexus, but generally why would you need one MAC address to be assigned to more than one port ? I did read somewhere that you can add more interfaces with this command (on general L2/L3 switches), but you need to more interfaces by repeating the command.. try it one by one... but still not sure of your design requirement.

Hope this helps.. all the best..

Raj