Nexus 6 K | getting repeat message | last message repeated 1 time

[Ramesh Babu]

Dear Team,

We are getting following error on the nexus switch,

 cisco Nexus 6001 Chassis

 version 6.0(2)N2(3)

Syslog:

2017 May 27 23:47:17 switch01 last message repeated 1 time

We are receiving above error repeatedly.

Hence kindly do the needful.

Thanks & Regards,

Ramesh Babu.A. 

[Georg Pauwen]

Hello,

this is not so much an error message as it rather is a standard feature in Nexus to cut down on the size of the syslog.

You can disable the message with:

conf t
logging compression disable

no logging rate-limit

[Ramesh Babu]

Hi Georg,

If we execute this command then we can able to see the logs ?

Its possible.

Thanks & Regards,

Ramesh Babu.A.

[Georg Pauwen]

Hello,

as I understand it, both commands shorten the log. By disabling rate limiting and compression, everything will show up in your log, making it longer...

[Ramesh Babu]

Hi Georg,

Unfortunate both (compression & rate-limit) command not available,

# logging ?

abort   -    Flushes cached data without committing and releases the lock
commit   -   Commits cached data (of all msg types) and releases the lock
console   -   Set console logging
distribute   -   Enables/disables fabric distribution using cfs.
event   -   Interface events
ip   -   IP configuration
level   -   Facility parameter for syslog messages
logfile   -   Set File logging
message   -   Interface events
module   -   Set module(linecard) logging
monitor   -   Set terminal line(monitor) logging level
server   -   Enable forwarding to Remote Syslog Server
source-interface   -   Enable Source-Interface for Remote Syslog Server
timestamp   -   Set logging timestamp granularity

Hence kindly do the needful to fix this issues.

[Reza Sharifi]

Like I said in my first post, the command is not available in all versions. If you have to use this command then you need to upgrade to a later version. 

[Ramesh Babu]

Ok sure Thanks.

Thanks for your help.

[Reza Sharifi]

Hi,

I am not sure if your version support the "no logging rate-limit" command:

available options with running 6.0(2)N1(2) are:

console 
distribute 
event 
ip 
level 
logfile 
message
module 
monitor 
server 
source-interface 
timestamp 

HTH