cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1010
Views
0
Helpful
1
Replies

Nexus 7000: How do I remove interfaces from a port-channel when those interfaces no longer exist?

cschaus
Beginner
Beginner

I need to add interfaces to a production port-channel.  The problem is that I am at the 8 interface limit for the port-channel, and I have 6 interfaces assigned to the port-channel that were interfaces on blades that are no longer in the chassis.  I don't want to have to delete the Port-channel as it is my VPC peer-link.  is there anyway of removing these interfaces without deleting the port-channel interface or putting a card in those empty slots and then removing them?

 

 

N7K-02# sho port-channel summary interface po1
Flags:  D - Down        P - Up in port-channel (members)
        I - Individual  H - Hot-standby (LACP only)
        s - Suspended   r - Module-removed
        S - Switched    R - Routed
        U - Up (port-channel)
        M - Not in use. Min-links not met
--------------------------------------------------------------------------------
Group Port-       Type     Protocol  Member Ports
      Channel
--------------------------------------------------------------------------------
1     Po1(SU)     Eth      NONE      Eth1/1(D)    Eth1/2(P)    Eth4/1(r)
                                     Eth4/2(r)    Eth7/1(r)    Eth7/2(r)
                                     Eth9/1(r)    Eth9/2(r)    

1 Reply 1

Leo Laohoo
Hall of Fame Community Legend Hall of Fame Community Legend
Hall of Fame Community Legend

Duplicate thread. 

 

Go HERE.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers