cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
6501
Views
15
Helpful
9
Replies

Nexus 7000 Show int Summary

alanjbrown
Beginner
Beginner

Can anyone tell me if there is an equivalent command to Show int Summary on the Nexus 7000 ?

eg

MYCISCOSW01#show int summary

*: interface is up
IHQ: pkts in input hold queue     IQD: pkts dropped from input queue
OHQ: pkts in output hold queue    OQD: pkts dropped from output queue
RXBS: rx rate (bits/sec)          RXPS: rx rate (pkts/sec)
TXBS: tx rate (bits/sec)          TXPS: tx rate (pkts/sec)
TRTL: throttle count

  Interface               IHQ   IQD  OHQ   OQD  RXBS RXPS  TXBS TXPS TRTL
-------------------------------------------------------------------------
  TenGigabitEthernet2/1    0     0    0     0     0    0     0    0    0
  TenGigabitEthernet2/2    0     0    0     0     0    0     0    0    0

I find it a useful command on the 6500 to spot high traffic flows.

thks

Al

1 Accepted Solution

Accepted Solutions

I use two comand line to achieve the similar resulte as "show int summary" although it is not so convenient. hope it is helpful for you.

show int | grep line-number rate | ex output | sort -k 6nr | head lines 10           -------sort by rate in descending order

show int | grep line-number . | grep prev 10 :      ---------------------position the corresponding interface

View solution in original post

9 Replies 9

Jerry Ye
Cisco Employee
Cisco Employee

May be show interface counter is what you are looking for?

HTH,

jerry

Nice try, but no cigar!

thks

Al