09-19-2016 07:47 AM - edited 03-08-2019 07:28 AM
Does anyone know how I can enable & configure Multicast on a single SVI? I cannot have multicast leave that vlan. I have PIM feature enabled and I have PIM sparse mode running on the SVI. I am not sure how to setup the "ip igmp snooping querier" or set up a RP on that specific SVI.
09-19-2016 08:43 AM
"ip igmp snooping querier" is enabled when you enable PIM.
For RP configuration see this document.
http://www.cisco.com/c/en/us/td/docs/switches/datacenter/sw/5_x/nx-os/multicast/configuration/guide/n7k_multic_cli_5x/pim.html
HTH
09-19-2016 09:19 AM
Couldn't I just do this on layer two?
vlan 111 |
vlan configuration 111 |
ip igmp snooping querier "SVI ateway address" |
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: