Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have (2) 2921's each connected to its own 2960-X. The 2960-X's are Layer2 only and connected via a port channel. I cannot seem to get this to work right. Diagram is attached.
switch's have the command ip default-gateway 10.255.193.1 <-- HSRP VIP...
I need a to advertise a static route from one router that has a bgp link to another router. Router two has a prefix list to allow routes from BGP to be redistributed in EIGRP.
R1
Static Route
ip route vrf blue 10.10.10.8 255.255.255.248 10.10.10....
I have a site that terminates to an ASA HA pair active / standby. That ASA is connected to a pair of L2 only 2960-X's. The 2960's are then connected to 2921's One will be primary and one is a backup link. I have HSRP running between the ASA and the ...
I am designing a temporary connection at a site with dual router redundancy running HSRP. I have two 2911 connected via 2 switches for HSRP. I need to manage those switches from behind the router. What would best practice determine I should use to ma...
Does anyone know how I can enable & configure Multicast on a single SVI? I cannot have multicast leave that vlan. I have PIM feature enabled and I have PIM sparse mode running on the SVI. I am not sure how to setup the "ip igmp snooping querier" or s...
No I cannot. It is almost like the port-channel doesn't work "but" I can ping from management to management across the switches. If I debug HSRP I can see hellos leave each router on the f0/1.100 sub-interface but I never see replies.
Jon,
I apologize for the configuration confusion. I was hoping someone had similar 2960TT-L or TC-L's in their lab to just test the concept. This was never about defining the configuration it was more about why it doesn't work. They are running IPba...
