Nexus Switch SPAN

[johnlloyd_13]

hi,

i need to configure a nexus switch to SPAN a port-channel interface on a certain VLAN.

port-channel6 is a dot1q trunk to a FW.

can someone confirm that i will only see traffic coming from port-channel6 and "filtered" to VLAN 10 only?

NEXUS# show monitor session 1
session 1
---------------
type : local
state : up
acl-name : acl-name not specified
source intf :
rx : Po6
tx : Po6
both : Po6
source VLANs :
rx : 10
destination ports : Eth1/30

[M02@rt37 · Accepted solution]

Hello @johnlloyd_13 

Only packets that are received on your Po6 and belong to vlan10 will be mirrored.

[johnlloyd_13]

hi,

thanks for the confirmation!

appreciate it