12-17-2012 10:03 PM - edited 03-07-2019 10:40 AM
Hi,
I'm running n7000 image 5.2.7 on my nexus 7000 box. The module 1 does not come up. The LC is N7K-M148GS-11L. The card requires Cisco NX-OS 5.0 or above.
Please let me know if some information is available on this. "show module" output is as below:
switch# show mod
Mod Ports Module-Type Model Status
--- ----- ----------------------------------- ------------------ ----------
5 0 Supervisor module-1X N7K-SUP1 active *
6 0 Supervisor module-1X N7K-SUP1 ha-standby
Mod Sw Hw
--- -------------- ------
5 5.2(7) 3.0
6 5.2(7) 3.0
Mod MAC-Address(es) Serial-Num
--- -------------------------------------- ----------
5 d8-67-d9-03-73-f0 to d8-67-d9-03-73-f8 JAF1624AGTH
6 d8-67-d9-03-99-98 to d8-67-d9-03-99-a0 JAF1624AJBG
Mod Online Diag Status
--- ------------------
5 Pass
6 Pass
Xbar Ports Module-Type Model Status
--- ----- ----------------------------------- ------------------ ----------
1 0 Fabric Module N/A powered-dn
2 0 Fabric Module N/A powered-dn
3 0 Fabric Module N/A powered-dn
Xbar Power-Status Reason
--- ------------ ---------------------------
1 powered-dn Unknown card (Could not get software-card-id)
2 powered-dn Unknown card (Could not get software-card-id)
3 powered-dn Unknown card (Could not get software-card-id)
Xbar Sw Hw
--- -------------- ------
Xbar MAC-Address(es) Serial-Num
--- -------------------------------------- ----------
* this terminal session
Thanks,
Nilesh
12-17-2012 10:07 PM
Why are your FAB-1 cards powered down?
What do you see in the "sh logs"?
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide