I do not see the 2 FE ports in sh ip int br. I don't see how to enable the card. card-type is not an option
show version
Cisco IOS Software, 2800 Software (C2800NM-ADVIPSERVICESK9-M), Version 12.3(11)T11, RELEASE SOFTWARE (fc3)
Cisco 2821 (revision 53.51) with 247808K/14336K bytes of memory.
Processor board ID FTX1041A2KL
3 Gigabit Ethernet interfaces
1 Virtual Private Network (VPN) Module
DRAM configuration is 64 bits wide with parity enabled.
239K bytes of non-volatile configuration memory.
62720K bytes of ATA CompactFlash (Read/Write)
show diag
Slot 1:
Unknown (type 919) Port adapter
Port adapter is disabled
Port adapter insertion time unknown
EEPROM contents at hardware discovery:
Hardware Revision : 1.0
Top Assy. Part Number : 800-21601-02
Board Revision : B0
Deviation Number : 0-0
Fab Version : 01
PCB Serial Number : JAE0826MRLG
RMA Test History : 00
RMA Number : 0-0-0-0
RMA History : 00
Product (FRU) Number : NM-2FE2W-V2=