Switching

I recently purchased a WAP54G to use with my WRT54GL router as a wireless repeater.  I entered the wireless MAC address of my router into the WAP54G and selected wireless repeater.  However, the link light will not come on and I cannot get it to act ...

Hi! I have a Catalyst 2960 series Switch. It is nothing wrong with the Switch. However when i type in the ip-adress of the Switch in IE (http://xx). And select Dashboard. The Switch Health displays 0% on "Bandwidth Used" and 0% "Packet Error". The Fa...

Hello everyone,I have a question on Vlans for you...I recently added a vlan to a Cisco 3524xl (SW1) which is connected to a 3508.  I configured trunking on SW1 on G0/1 and added the "switchport access vlan 22" statement to the rest of the ports excep...

   Hello,I have a setup where I have a 6509 with no SVIs. I need to create different dhcp pools that will be used for voice without creating SVIs, is this possible? how?

hello world,i'm trying to limit bandwitdh with a Catalyst 2960as to users from a port are limited for upload and dowload speed 80 Mbpsi tried with policy-map attached to a port but i don't understand how to fix the burst size ::does any one could hel...

I have a client who are in process of moving some of their hosts/servers  from the  Data Center to their own Campus.  They don't want to change the IP addresses and thinks that they can extend the VLANS over GRE/IPSEC tunnel.  They are running a fibe...

I have a switch stack of 3750's running IPServices 12.2(25)SEE4. I was wanting to implement a route-map to direct certain addresses with in a VLAN to be routed to another default route. Though when I apply the command on the vlan interface, it does n...

Has anyone seen this log message beforewhen attempting to configure a 2-port layer 3 EtherChannel on the same line card (WS-X6148-GE-TX), the following syslog messages were generated. Aug 12 16:15:58.497 EST: %PM-SPSTBY-3-INTERNALERROR: Port Manager ...