03-11-2024 04:02 AM
Hallo,
2960x switch here.
I would like to remove enable password so I did: "no enable secret".
However now after trying to run command "enable", it asks for a password (not the old one) that I don't know.
I kept another active session so I didn't lock me out.
How can I remove the password so when I run command "enable" it doesn't ask for password ?
Thanks
03-11-2024 04:21 AM
Hello bevdaamrut,
After removing the enable secret password....save the configuration and restart the switch...
Switch(config)# no enable secret xxxxxx
Switch(config)# exit
Switch# write memory or Switch# copy running-config startup-config
Switch# reload
Best regards
******* If This Helps, Please Rate *******
03-11-2024 04:46 AM
To remove the enable password prompt on your 2960x switch, use the following steps. Enter global configuration mode with "configure terminal," remove the enable password with "no enable password," exit configuration mode, and verify that neither enable password nor enable secret is configured using "show run | include enable." Save the configuration with "write memory" to make the changes permanent. After completing these steps, the "enable" command should not request a password.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide