No "show ip cef" command in Nexus?

[caobo1020]

Hi Experts,

I just realize it seems we don't have 'show ip cef' command in Nexus series. But cisco doc says it's using cef. Is there a cef table exists in Nexus?

Thanks,

Bo

[Jerry Ye]

You need to find the route that you are looking for first, then attach to the module then use the command show forwarding ip route. Below is an example:

Nexus1# sh routing 10.50.200.0

10.50.200.0/24, ubest/mbest: 1/0

    *via 10.51.254.6, Eth3/7, [110/20], 04:38:48, ospf-10, intra

Nexus1# attach mod 3

Attaching to module 3 ...

To exit type 'exit', to abort type '$.'

module-3# sh forwarding ip route

IPv4 routes for table default/base

------------------+------------------+----------------------+-----------------

Prefix            | Next-hop         | Interface            | Labels

------------------+------------------+----------------------+-----------------

10.50.200.0/24      10.51.254.6       Ethernet3/7        

HTH,

jerry

[caobo1020]

Thanks Jerry.

The following command also works

#show forwarding route 10.50.200.0

Bo

[FT1]

Thanks, it works