09-29-2009 01:38 AM - edited 03-06-2019 07:55 AM
on WS-X6148-GE-TX module installed in 6509
related information :
#sh module
Mod Ports Card Type Model Serial No.
--- ----- -------------------------------------- ------------------ -----------
1 48 48-port 10/100/1000 RJ45 EtherModule WS-X6148A-GE-TX SAL10436BBF
2 48 48-port 10/100/1000 RJ45 EtherModule WS-X6148A-GE-TX SAL104369DS
3 48 48-port 10/100/1000 RJ45 EtherModule WS-X6148A-GE-TX SAL10436BCD
4 48 48-port 10/100/1000 RJ45 EtherModule WS-X6148A-GE-TX SAL104369E9
5 3 Supervisor Engine 32 10GE (Active) WS-SUP32-10GE-3B SAL1020NDWX
6 3 Supervisor Engine 32 10GE (Hot) WS-SUP32-10GE-3B SAL1020NDYA
7 48 48-port 10/100/1000 RJ45 EtherModule WS-X6148A-GE-TX SAL11466XUY
8 48 48 port 10/100/1000mb EtherModule WS-X6148-GE-TX SAD075100U2
SWE(config)#int Gi 8/15
SWE(config-if)#switchport mode trunk
SWE(config-if)#switchport trunk enca
SWE(config-if)#switchport trunk ?
allowed Set allowed VLAN characteristics when interface is in trunking mode
native Set trunking native characteristics when interface is in trunking mode
pruning Set pruning VLAN characteristics when interface is in trunking mode
Swe(config-if)#switchport trunk
Solved! Go to Solution.
09-29-2009 02:28 AM
Sanjay
The WS-X6148-GE-TX only supports 802.1q encapsulation and that is why you do not have the CLI option to set encapsulation.
Jon
09-29-2009 02:28 AM
Sanjay
The WS-X6148-GE-TX only supports 802.1q encapsulation and that is why you do not have the CLI option to set encapsulation.
Jon
09-29-2009 02:56 AM
Jon
Thanks for the prompt response.Actually
i have one migration activity sceduled
in this week, I have to connect HP blade
centre on the 6509 switch. The physical
connection needs to be done with WS-X6148-GE-TX module
Thanks again !
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide