11-18-2017 11:14 PM - edited 03-08-2019 12:47 PM
Dears,
I get the below logs in the router , but the time is in sync properly I don't know what does the error mentioned ,, hence I tried to search but couldn't find related to the error, can any body explain me what exactly the error is.
The router models are 2851: c2800nm-advsecurityk9-mz.151-4.M10.bin and 1941: c1900-universalk9-mz.SPA.155-3.M5.bin
NTP Core (NOTICE): ntp_receive: dropping message: MODE_PRIVATE restriction.
Thanks
11-18-2017 11:50 PM
11-19-2017 10:01 PM
Dears
I am not running NTP v4 there are normal NTP commands how I can know whether it is enabled or not ??
thanks
11-19-2017 10:04 PM
11-20-2017 08:27 AM
11-21-2017 10:01 AM
11-21-2017 10:49 AM
Hello,
post the output of 'show ntp information', it should look something like below:
Router#sh ntp information
Ntp Software Name : Cisco-ntpv4
Ntp Software Version : Cisco-ntpv4-1.0
Ntp Software Vendor : CISCO
Ntp System Type : Cisco IOS / NPE400
08-26-2021 02:28 AM
I'm on a Cisco CAT 9500-16x IOS-XE Gibraltar 16.12.x and I also get this error too. How may I stop this as well?
DRF312cisco-WWW#show ntp information
Ntp Software Name : Cisco-ntpv4
Ntp Software Version : Cisco-ntpv4-1.0
Ntp Software Vendor : CISCO
Ntp System Type : Cisco IOS / X86
DRF312cisco-WWW(config)#no ntp allow mode private
%NTP: This configuration command is deprecated.
DRF312cisco-WWW(config)#
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide