I have the follow error in a 7609:
c1#sho int tra
Transceiver monitoring is disabled for all interfaces.
If device is externally calibrated, only calibrated values are printed.
++ : high alarm, + : high warning, - : low warning, -- : low alarm.
NA or N/A: not applicable, Tx: transmit, Rx: receive.
mA: milliamperes, dBm: decibels (milliwatts).
Optical Optical
Temperature Voltage Current Tx Power Rx Power
Port (Celsius) (Volts) (mA) (dBm) (dBm)
--------- ----------- ------- -------- -------- --------
Te1/1 40.2 ++ 0.00 103.9 ++ 1.0 ++ -4.4 ++
Te1/2 27.1 ++ 0.00 61.0 ++ 0.3 ++ -5.5 ++
Te1/4 29.7 ++ 0.00 47.2 ++ -1.5 ++ -2.1 ++
Gi9/24 41.2 ++ 3.26 ++ 17.8 ++ -6.8 ++ -11.6 ++
c1#sho int statu
Port Name Status Vlan Duplex Speed Type
Te1/1 connected routed full 10G 10Gbase-ZR
Te1/2 connected routed full 10G 10Gbase-ER
Te1/4 connected routed full 10G 10Gbase-LR
Gi9/24 connected routed full 1000 1000BaseLH
c1#sho idprom int te1/1 | inc r n
Transceiver vendor name :CISCO-OPNEXT,INC
c1#sho idprom int te1/2 | inc r n
Transceiver vendor name :CISCO-INTEL
c1#sho idprom int te1/4 | inc r n
Transceiver vendor name :CISCO-OPNEXT,INC
c1#sho idprom int gi9/24 | inc r N
Vendor Name : ATI
c1#sho mod
Mod Ports Card Type Model Serial No.
--- ----- -------------------------------------- ------------------ -----------
1 4 CEF720 4 port 10-Gigabit Ethernet WS-X6704-10GE SAL1304Hxxx
9 24 CEF720 24 port 1000mb SFP WS-X6724-SFP SAL1306Jxxx
How should I do?
Thank you very much.
