02-13-2019 03:19 AM - edited 03-08-2019 05:19 PM
I was not sure where to post this so if I am in the wrong location I am sorry.
So basically I am trying to design a network to a number of specific criteria and one of these I am having trouble with remembering how to configure OSPF on a layer 3 switch, I have made sure all IP routing is enabled on the switches and that I have IP's for the specific interfaces ie 10.0.0.2/30 etc. My lecturer was saying that I have to enable OSPF on the specific interfaces however he doesn't know how to / he wants us to find out ourselves so how would I go about adding the OSPF to the interfaces? I apologize if I have been very vague I am not too sure how to ask the question. I have the correct logical order for the IP's eg one network is .1/30 next is .2/30 then the next interface is .5/30 .6/30 etc I have all this configured It is just about configuring OSPF on the 5 layer 3 switches. TIA for any help.
PS I am only a student so I may be slightly ignorant in my answers but I will try my best!
02-13-2019 10:58 PM
It is explained here:
https://www.cisco.com/c/en/us/td/docs/ios-xml/ios/iproute_ospf/configuration/xe-3se/3850/iro-xe-3se-3850-book/iro-cfg.html
you can also watch and learn here:
https://www.youtube.com/watch?v=LvdIk93Q9W8
02-14-2019 04:05 AM
02-14-2019 05:13 AM
If you the question was all about just enabling ospf between switch under interface level then i think the attached image would help you.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide