Switching

Discuss Catalyst brand switches with peers and experts.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Labels

Forum Posts

Hi All, I have a small query on VPC mac address table.   Lets say I have below topology.   N7K1                                             N7K2  |                                                       |  |                                            ...

Good Day All,   We have a huge problem that might be small to some of you.   We have a nexus core switch which has the following configs;   interface Vlan3vrf member Trustip address 10.10.3.1/24ip dhcp relay address 10.10.4.20description Wireless_Man...

mathemba by Level 1
  • 2218 Views
  • 15 replies
  • 0 Helpful votes

I am using a router as ntp server (it is master).And other devices on the network are configured as slave.When I run the show ntp status command, I check that the slave is not configured with the master address.Can someone help me ?To be more enlight...

oi.png
eduangelo by Level 1
  • 1488 Views
  • 7 replies
  • 0 Helpful votes

Hello,   I have cisco core 4500 configured on it DHCP, The DHCP POOL configured and IP excluded range was configured too.   The PC's and Printer taking automatically the IP's, but when I setup static IP on PC & printer I can't ping the default gatewa...

I have the below query:- HSRP tracking allows to tracking of the status of the interface status for the line protocol- Based on that I allows to decrement or increment the priority. Would like to check is there any mechanism by which we can track the...

RS19 by Level 4
  • 1346 Views
  • 6 replies
  • 0 Helpful votes

Hi to all, I didn't mean to have PWR-C1-1100WAC as default module into my switch (WS-C3850-48F-S), so i would like to know if i can replace this module with PWR-C1-715WAC ? My current 1100W module is noisy (fan noise) and i thinks that it will reduce...

My user distribution layer consists of a pair of 4500X-32 running XE 3.4.2.SG configured as VSS.  I want to upgrade the license from IP base to enterprise (because I need vrf-lite), and I want the upgrade to be seamless.  I also want to do it online,...

Resolved! NAT Doubts

Hello guys,I configured the internet output interface with the ip obtained through DHCP.Now I want to configure static NAT to allow external access to the HTTP server.But as the external address is the address obtained through DHCP.There will be time...

eduangelo by Level 1
  • 1426 Views
  • 4 replies
  • 0 Helpful votes

Hi folks, I hope someone can help me with this. I've attached a network diagram of my network setup but the problem I'm having is the MS120 devices are not connecting to the cloud nor am I getting internet connectivity from the MR42 device connected ...

When I do License install bootflash:with the license name, I get a duplicate license error.  And I see the license in my flash.  So I assume the license is installed and that I just need to activate it.   But but the command license boot level Boost ...

cmparish5 by Level 1
  • 3623 Views
  • 4 replies
  • 0 Helpful votes