ospf network metric control per neighbour

[Reza Zand]

Hi, I want Router IOU3 receive network 10.10.1.0/24 from IOU4 and network 10.10.2.0/24 & 10.10.3.0/24 from IOU2.

Is this possible and how?

[Rolf Fischer]

Hi,

I assume 10.10.1/24 is an OSPF internal network and all links belong to the same area?

On R3 you could control by a distribute-list which routes are allowed to be installed in the routing table but that's probably not what you're looking for.

Another option is to put 10.10.1/24, 192.168.3/24 and 192.168.4/24 in another area.

Link-State routing protocol path manipulation can really be a challenge, especially in single-area designs. If you elaborate a bit on your requirements, we may be able to provide better support.

HTH
Rolf

[Reza Zand]

Hi Rolf

Thanks for  your replay

But I want to be able to control these routing manipulation on R1. In another hand, R1 control each network originate from specific interface.