ā01-16-2016 11:55 PM - edited ā03-08-2019 03:26 AM
Hi, I want Router IOU3 receive network 10.10.1.0/24 from IOU4 and network 10.10.2.0/24 & 10.10.3.0/24 from IOU2.
Is this possible and how?
ā01-17-2016 08:26 AM
Hi,
I assume 10.10.1/24 is an OSPF internal network and all links belong to the same area?
On R3 you could control by a distribute-list which routes are allowed to be installed in the routing table but that's probably not what you're looking for.
Another option is to put 10.10.1/24, 192.168.3/24 and 192.168.4/24 in another area.
Link-State routing protocol path manipulation can really be a challenge, especially in single-area designs. If you elaborate a bit on your requirements, we may be able to provide better support.
HTH
Rolf
ā01-19-2016 02:07 AM
Hi Rolf
Thanks for your replay
But I want to be able to control these routing manipulation on R1. In another hand, R1 control each network originate from specific interface.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide