I am getting a ton of OutDiscards on both of the ports of a port-channel. I am not sure how to resolve. Could some provide some help? Below is the port configs of the problem ports:
interface GigabitEthernet1/0/6
description to s-sctrcr-2355-1
switchport trunk encapsulation dot1q
switchport trunk allowed vlan 2-899,1100-1499,2500-3899,3969,4070-4074
switchport mode dynamic desirable
logging event trunk-status
logging event bundle-status
logging event spanning-tree
logging event status
channel-group 1 mode on
spanning-tree cost 20
interface GigabitEthernet2/0/6
description to
switchport trunk encapsulation dot1q
switchport trunk allowed vlan 2-899,1100-1499,2500-3899,3969,4070-4074
switchport mode dynamic desirable
logging event trunk-status
logging event bundle-status
logging event spanning-tree
logging event status
channel-group 1 mode on
Could it be just a dirty optic? Bad cable? Thanks in advance.
Disclaimer
The Author of this posting offers the information contained within this posting without consideration and with the reader's understanding that there's no implied or expressed suitability or fitness for any purpose. Information provided is for informational purposes only and should not be construed as rendering professional advice of any kind. Usage of this posting's information is solely at reader's own risk.
Liability Disclaimer
In no event shall Author be liable for any damages whatsoever (including, without limitation, damages for loss of use, data or profit) arising out of the use or inability to use the posting's information even if Author has been advised of the possibility of such damage.
Posting
Could it be offered load more than egress capacity?