07-10-2013 02:30 AM - edited 03-07-2019 02:19 PM
hi. i'm trying to use this command in packet tracer 6 with OSPF
" ip ospf network-type point-to-point"
but i've noticed that does not work.
anyone knows if it is supported or not ?
07-10-2013 02:40 AM
Not sure of 6. I have 5.3 version and this is working fine there.
Router(config)#int s0/3/0
Router(config-if)#ip ospf network point-to-point
Router(config-if)#exit
Router(config)#
HTH
Regards
Inayath
07-12-2013 02:24 AM
i mean if a try to use it with a LOOPBACK interface, it does not work.
can i create a LOOPBACK interface, and then advertise it, without / 32 in packet ?
that's what i want to do....
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: