09-16-2008 08:37 AM - edited 03-06-2019 01:24 AM
I am writing a script to use "show ip protocol | include passive interface". but this command is not giving me the actual passive interface number. I have passive interface at this point but didn't show up here.the output is just like this.
router#sh ip protocols | include Passive
Passive Interface(s):
is there any other command to find out the current passive interface on the router.
thanks.
Solved! Go to Solution.
09-16-2008 08:45 AM
sh run | include passive-interface
should show you the actual passive interfaces under the router protocol
Jon
09-16-2008 08:45 AM
Elias
Have you considered this:
show run | include passive
HTH
Rick
09-16-2008 08:45 AM
sh run | include passive-interface
should show you the actual passive interfaces under the router protocol
Jon
09-16-2008 08:45 AM
Elias
Have you considered this:
show run | include passive
HTH
Rick
09-16-2008 08:52 AM
thank you so much!!!
09-16-2008 09:10 AM
Elias
I am glad that our suggestions were able to resolve your question. Thank you for using the rating system to indicate that your question was resolved (and thanks for the rating). It makes the forum more useful when people can read a question and can know that there were answers that did resolve the question.
The forum is an excellent place to learn about Cisco networking. I encourage you to continue your participation in the forum.
HTH
Rick
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide