PBR on 6500

[Khalid DOUMAL]

Hello Experts,

We have a 6500  where we configured a PBR on one SVI  as discribed on the file attached,

when make the traceroute from the server we see that the PBR is working very well  ( trafic go through GW2 )

for test purpose we created an SVI 20  on Access swtich : when we made a trace route from Access SW with source SVI 20 the 6500 don't apply the PBR for this kind of traffic. ( traffic go through default GW  GW1) !!!!

Thanks for your help

[Reza Sharifi]

Hi,

Most small switches with basic license don't support PBR.  For example; if you are using a 3560 or 3750 with IP base license, it will not support PBR.  You would need IP services license to do PBR.

HTH

[Khalid DOUMAL]

Hi,

Thanks for your answer,

The PBR is applayed on the 6500 SVI 20 .

when we made the traceroute from the server ( IP@ : 10.10.12.100 ) we see that the GW is corrcet PBR worked very well.

when we made the trace from Aceess Switch ( trace source is 10.10.12.2) the traffic follow the default path!!! PBR not applayed !!!.

Br

[Reza Sharifi]

Thanks for the clarification

Can you post the PBR config from the 6500?

[Khalid DOUMAL]

Hi,

here you are :

access-list 100 permit ip 10.10.12.0 0.0.0.255 10.10.15.0 0.0.0.255

route-map PBR_NET15 permit 10

  match ip address 100

  set ip next-hop 10.10.14.1

int vlan 20

ip address 10.10.12.1 255.255.255.0

ip policy route-map PBR_NET15

Kind regards

Khalid

[nokialabcd]

I met a similar problem as this. The PBR doesn't work as expected. It's overided by static route.

Just posted a question and hope can find answers

https://supportforums.cisco.com/message/4022951#4022951