Buy or Renew
Buy or Renew

Switching

Discuss Catalyst brand switches with peers and experts.
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation

Labels

Forum Posts

Start a conversation

MPLS VPNs (MP-BGP) .... show advertised routes ?

Hi,I have an issue where our router is not advertising some routes out to its MPLS neighbour (MP-BGP)I really need to see if the router is advertising routes out. Do you know how I can achieve this … I am looking for an similiar command....BGP WORLD ...

mcroft by • Level 1
  • 2319 Views
  • 1 replies
  • 0 Helpful votes

IOS 15.X for Catalyst 4500 switches support of global commands like in 2XXX and 3750 Catalyst switches

Hi ,I would like to know if  new command like no authentication logging verbose ,no dot1x logging verbose , no mab logging verbose will be supported in IOS 15.Xfor Cat 4500 switches like it is supported for other switches( i.e. 3750).Question: Is it ...

h.schwob by • Level 1
  • 906 Views
  • 1 replies
  • 0 Helpful votes

Resolved! Layer 3 switch supporting NAT/PAT needed

Hi all,I'm looking for a low cost switch that supports layer 3 IP routing along with NAT/PAT functionality.Ideally it will have 24 RJ45 GbEth ports.Can anyone suggest a suitable model.Also, I have read that the 2960 model switches support basic layer...

3750X Jumbo Frames

HiI've got a Cisco 3750X stack pair and "show system mtu" reports:System MTU size is 1500 bytesSystem Jumbo MTU size is 9000 bytesRouting MTU size is 1500 bytesEverything I've read suggests that this means I've got Jumbo Frames enabled. However, ther...

Why haven't I got outgoing multicast traffic?

Hello, before starting just state that I'm newbie with multicast and maybe I'm asking some trivial thing...I would like to multicast some video footage from some cameras which are plugged to catalyst 3750. In order to do so, I have a multicast camera...

ndarkness by • Level 1
  • 766 Views
  • 0 replies
  • 0 Helpful votes

Fabric Path/TRILL in a 2-post core (?)

Hi - wondering what the benefit is of running FP in a 2-post core - in other words, not in a folded CLOS that requires more than 2 active L2 paths. Sure, you either totally remove STP or at least mitigate the STP domain, but you are also replacing ST...

visitor68 by • Level 5
  • 1282 Views
  • 7 replies
  • 0 Helpful votes

1841 Flash Memory Card Problem

Hello Community,   We're in a bit of a small pickle here. So we have a 1841 router. It's got a 32MB flash card. We bought a 64MB Cisco flash card. We hot swapped the cards while the router was still running. Then we formatted the 64MB flash card. The...

milkboy33 by • Level 1
  • 3667 Views
  • 4 replies
  • 0 Helpful votes

Resolved! Switch model advice

I have a Cisco 5520 firewall that I want to VLAN connect to a WLC and 5 AP's so I can separate into a inside corporate network and a guest network that will just have access to the Internet. I need a good PoE and layer 3 switch? Any recommenations? I...

Resolved! Quick IP SLA Question

route outside 0.0.0.0 0.0.0.0 75.1.1.1 1route outside 0.0.0.0 0.0.0.0 75.1.1.1 1 track 1Just a quick question, if I modified a config to include the IP SLA track and left the original default route, would the SLA be effective, or not? (See above)

Load more
Unanswered Topics
View All