per IP limitation

[mohamed.ali]

Dears,

I have Cisco router as well I'm activating 3 DHCP pool, how can I limit the traffic based per IP?

if it's not available there is another way to limit the user?

thanks in advance

[Mark Malone]

Hi

if you want to restrict traffic to a specific ip address you can use MQC QOS and match against the ip address you want to restrict

there are several examples in this doc

basically create a class map then a policy map and match against an acl then apply it to the interface in and out

https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst3850/software/release/3se/qos/configuration_guide/b_qos_3se_3850_cg/b_qos_3se_3850_cg_chapter_011.html#d9712e18950a1635

[mohamed.ali]

sir, is this config accepted by the router ?

[Mark Malone]

yes that will work fine on router too , its exact same actually MQC is supported on routers and layer 3 switches like 36 and 38s , what exactly is your router model ?

[Mark Malone]

heres one for a 800 series router same concept again

https://www.techrepublic.com/article/configure-qos-on-your-cisco-router-with-this-template/