point to point connection
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
07-08-2019 11:06 PM
We have a new office (site- B) just two building far from our office (site-A), we have to create p2p connectivity between both office and carry all vlans from site-A to site-B all traffic go through site A . we have taken p2p connectivity from service provider and for the connectivity we are using core switch(cisco 6504) site-A and cisco router 4451 for site-B.
so what configuration we have to do both site to communicate both site.
- Labels:
-
Catalyst 6000
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
07-09-2019 12:28 AM
This is just an option but you can use a layer 3 SVI say on each side and that can be the routed p2p interfaces as an l3 overlay running an IGP like EIGRP over an L2 trunk ,then actually use a physical trunk on the link in layer 2 mode with all vlans allowed.Thats one way to do it.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
07-09-2019 01:55 AM
Hello
@bhupinder.singh1 wrote:
We have a new office (site- B) just two building far from our office (site-A), we have to create p2p connectivity between both office and carry all vlans from site-A to site-B all traffic go through site A .
You dont mention what type of P2P connection this is but given what you have said about extending your vlans to both sites i am assuming it is a L2 vpls connection?
Please rate and mark as an accepted solution if you have found any of the information provided useful.
This then could assist others on these forums to find a valuable answer and broadens the community’s global network.
Kind Regards
Paul
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
07-09-2019 03:32 AM
Hi Paul,
Basically we want to expend site A, so pls suggest how we can do that.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
07-09-2019 04:47 AM
Hello
Have you acquired the P2P connection off the isp yet or are you seeking a suggestion on this also?
Please rate and mark as an accepted solution if you have found any of the information provided useful.
This then could assist others on these forums to find a valuable answer and broadens the community’s global network.
Kind Regards
Paul
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
07-09-2019 09:17 PM
Hi Paul,
We have taken p2p connection from ISP, now we have to do configuration part, so could you tell me what configuration we have to do both side.
