Port-Channel Interface Configuration EtherChannel and LACP in same Port-Channel

[lukesmith0788]

Hi,

I currently have two links which form a Port-Channel from 1 cisco device to another.

I want to change the port-channel config from

channel-group 1 mode on

to

channel-group 1 mode active

So that the Port-Channel is now running LACP, so I can also turn on lacp rate fast

To prevent any outage I was going to shut 1 of the interfaces in the Port-Channel change to LACP and rejoin the port-channel, but I was wondering is it possible to have 1 link running "on" and 1 link running "active" LACP in the same Port-Channel.

Any advice would be appreciated.

Thanks

Luke

[Mark Malone]

Hi

I would think the links will go standalone in etherchannel , be careful not to cause a loop

on mode uses no protocol so it wont mix with lacp and form a channel as it wont understand the negotiation