Port Channel is up but member interfaces are down

[dbuckley77]

We have a 4 member port channel setup.  the port channel is up but two of the member interfaces are showing up/down.  On the other side is not a Cisco switch but a PAlo Alto firewall and all interfaces on that end are configured correctly to be in the same aggregated link.

[Reza Sharifi]

The configuration you posted is for interfaces 1/5/25 and 1/5/26. The output you posted shows interfaces

2/5/25 and 2/5/26

Gi2/5/25     FA      down    32768         0x14     0x14     0x251A   0x47  
Gi2/5/26     FA      down    32768         0x14     0x14     0x251B   0x47 

So, we need to see the config for 2/5/25 and 26 if this is what you are trying to configure.

HTH