Hello, I have an issue all of a sudden with a cisco 2960
We have a MPLS connection between two sites which worked until 2-3 hours ago.
I did some work on the remote side today, but as I tested everything looked OK, only after I logged in aprx 1 hour later I saw that the MPLS Link is down.
My changes made today:
On the Firewall I created a new subinterface with Vlan45
Created an anyconnect profile using the new vlan as split-acl, also created the NAT for the anyconnect subnet to be able to speak to the new vlan.
On the switch created the Vlan45 as well, and changed the port 0/2 which goes to the fw to trunk and allow vlans1,45...later changed to all vlans after the issue started.
On the MPLS port changed the trunk ports to all except vlan45
That is all I did... I disabled the new subinterface on the fw. Deleted the anyconnect profile and settings, set the ports back as they were and deleted the vlan on the switch...but same.
Already restarted the switch, shutdown and no shutdown on port. Port has everything on auto.
Do you think this happened because of my configuration? Seems weird..
The latest modifications made (the 1 hour before I logged in again) were the anyconnect and the port 0/2, other ones were made several hours before and the link was still up.
Thank you!
