09-18-2011 09:02 PM - edited 03-07-2019 02:17 AM
hey all,
i have a port that is up/up but when i do a show mac-address interface ( interface) it dosnt desplay the ports mac address.
any ideas?
09-18-2011 09:29 PM
Hi Scott,
On which platform are you trying this command..I can't see this command on 3750X...."sh int
-ankur
09-19-2011 12:35 AM
Hi Scott,
Please follow the process below.
1) ping
2) show ip arp <ip-address>
3) sh mac address-table address
Also please check and confirm if an SVI is created on the swithc for VLAN subnet under consideration.
Please rate helpful posts.
Ameya
09-28-2011 08:39 PM
Hi Ameya,
unfortantly i dont have the devices IP address ( not showing up in DHCP)
the vlan and svi are working fine.
cdp neighbors dosnt show up any info about the device.
09-28-2011 08:47 PM
This happens when your server is configured as NIC teaming.
Try to ping the broadcast IP address of your server's IP address subnet.
09-30-2011 05:04 AM
Hi Scott,
you can try traceroute using mac address. Give it a go otherwise agree with Leolaohoo.
HTH.
Regards
Sukanta
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: